Table of Contents
Advertisement
SuperServer E403-9D-16C-IP User's Manual
Expansion Cards
The E403-9D-16C-IP supports up to three PCI-E slots on the riser card. Follow the table
printed on the riser card to set the JSEL jumper. The IIO configurations may also need to be
set in the BIOS.
Installing Expansion Cards
1. Power down the system and remove the AC power cord and the chassis cover.
2. Remove the screw as shown below and set aside.
3. Pull the locking lever up to release the expansion card module.
4. Pull the expansion card module upward with the aid of the plastic handle.
5. Set the jumper on the riser card and install expansion cards.
Expansion Card Module
Figure 3-10. Components of the Expansion Card Module
Locking Lever
Remove this screw
38
Plastic Handle
Advertisement
Table of Contents
