Canon imageCLASS MF6540 Reference Manual page 215

Before Using the
Machine 1
Cannot receive a document manually.
Document and Paper
2
Copying
3
Sending and Receiving (MF6595cx/
MF6595/MF6590 Only) 4
Printing and
Scanning
5
Network (MF6595cx/MF6595/
MF6590/MF6540 Only) 6
Remote UI (MF6595cx/MF6595/
MF6590/MF6540 Only) 7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
Q Is the machine set to receive manually?
A For the machine to receive faxes manually, the receive
mode must be set to <Manual>. (See "Basic Receiving
Method, " on p. 4-23.)
A If you set <MANUAL/AUTO> to <ON> in <RX
SETTINGS> in the <FAX SETTINGS> menu, the
machine will receive faxes automatically even when
the receive mode is set to <Manual>. (See "MANUAL/
AUTO, " on p. 11-17.
Q Did you hang up the external telephone before
pressing [Start] or dialing the remote reception ID?
A Always press [Start] or dial the remote reception ID
before hanging up. Otherwise you will disconnect the
call.
Q Are documents set on the ADF?
A After removing the document from the ADF, please
attempt manual receiving again. If you press [Start]
when documents are set on the ADF, it automatically
switches to manual sending.
Back
Print quality is poor.
Q Is the toner low or unevenly distributed?
A Redistribute the toner inside the toner cartridge. If
the problem persists, replace the toner cartridge. (See
"Replacing the Toner Cartridge, " on p. 9-13.)
Q Is the correct type of paper loaded in the machine?
A Make sure you load paper that meets the
requirements for use. (See "Paper Requirements, " on
p. 2-7.)
Q Is the sender's machine functioning properly?
A Ask the sender to check that the scanning
components of the machine are clean.
Q Is the machine in the toner saver mode?
A Set <TONER SAVER MODE> to <OFF>. (See "COMMON
SETTINGS, " on p. 11-5.)
TOP
Previous Next
10-28