Canon imageCLASS MF6540 Reference Manual page 123

Before Using the
Machine 1
Document and Paper
2
Copying
3
Sending and Receiving (MF6595cx/
MF6595/MF6590 Only) 4
Printing and
Scanning
5
Network (MF6595cx/MF6595/
MF6590/MF6540 Only) 6
Remote UI (MF6595cx/MF6595/
MF6590/MF6540 Only) 7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
8.
Click [Finish].
If the dialog box displays [Additional Port Information Required],
follow the instructions on the screen to search again, or click
[Standard] → click [Canon Network Printing Device with P9100] from
the pull-down list → click [Next].
9.
Click [Close] to close the [Printer Ports] dialog
box.
10.
In the printer properties dialog box, click
[Configure Port] → Click [LPR] under [Protocol]
→ enter a print queue in [Queue Name] under
[LPR Settings].
If you want to use Raw, confirm [Raw] under [Protocol] is selected,
and proceed to step 11.
Back Previous
You can specify a print queue in [Queue Name]. The following three
print queues are available:
LP: The machine prints according to its spool settings. Normally
select this option.
SPOOL: The machine prints only after spooling a print job on the
hard disk, regardless of its spool settings.
DIRECT: The machine prints without spooling a print job on the hard
disk, regardless of its spool settings.
11.
Click [OK].
12.
Click [Close].
TOP
Next
6-13