Canon imageCLASS MF6540 Reference Manual page 197

Before Using the
Machine 1
DOCUMENT TOO LONG
Document and Paper
Description
2
Copying
Action
3
Sending and Receiving (MF6595cx/
FEEDER PAPER JAM
MF6595/MF6590 Only) 4
CHECK THE FEEDER
Printing and
Description
Scanning
5
Action
Network (MF6595cx/MF6595/
LOAD PAPER
MF6590/MF6540 Only) 6
Description
Remote UI (MF6595cx/MF6595/
MF6590/MF6540 Only) 7
Action
System Settings
8
MEM IN USE nn%
Maintenance
Description
9
Troubleshooting
10
Action
Appendix
11
Table of Contents
Index
The document is longer than 24 7/8" (630 mm),
or is not feeding correctly.
– Scan the document on the platen glass.
– Reduce the length of the document to within
24 7/8" (630 mm), then try again.
A document jam may have occurred in the ADF.
Remove the jammed document
No paper is loaded in the paper cassette or
multipurpose tray, or not inserted correctly.
Insert the paper cassette as far as it will go or
load paper.
This message shows the percentage of the
memory currently in use. This message is
displayed when you set the document in the ADF
to send a fax.
If you need more space, wait for the machine to
send any faxes in memory. Also print, send, or
delete any documents stored in memory.
Back
MEMORY FULL
Description The machine is full of jobs.
Action – Print, send, or delete any documents stored in
memory.
– Divide the document stack or data into a few
parts and try again one by one.
– Send the document with low resolution.
– When this message appears during using the
ADF, the scanning document stops halfway. In
this case, clear the paper jam from the ADF.
Description The number of fax jobs that can be stored in
memory reached the maximum.
Action Wait for the machine to send any faxes in
memory. Also print, send, or delete any
documents stored in memory.
For information on the maximum numbers of
jobs that can be stored in memory, See Chapter
11, "Troubleshooting," in the Basic Operation
Guide.
TOP
Previous Next
10-10