Before Using the
Machine
1
Copying Problems
Document and Paper
2
Copying
Blank paper comes out from the machine.
3
Sending and Receiving (MF6595cx/
MF6595/MF6590 Only)
4
Printing and
Scanning
5
Network (MF6595cx/MF6595/
MF6590/MF6540 Only)
6
Remote UI (MF6595cx/MF6595/
MF6590/MF6540 Only)
7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
Q
Have you removed the plastic seal from the toner
cartridge?
A
Make sure you remove the seal from the cartridge.
(See "Set Up the Machine, " in the Starter Guide.)
Q
Is the toner cartridge installed properly?
A
Make sure the toner cartridge is installed properly.
(See "Set Up the Machine, " in the Starter Guide.)
A
Make sure the left cover is fully closed.
Q
Is the document loaded correctly?
A
Make sure the document is correctly loaded. (See
"Loading Documents, " on p. 2-4)
Back
Q
Is the cartridge out of toner?
A
Replace the toner cartridge. (See "Replacing the Toner
Cartridge, " on p. 9-13.)
Q
Does the document meet the requirements for the
machine?
A
Make sure you load documents that meet the
requirements for use. (See "Document Requirements, "
on p. 2-2.)
Copy is too light or has uneven density.
Q
Is the toner low or unevenly distributed?
A
Redistribute the toner inside the toner cartridge. If
the problem persists, replace the toner cartridge. (See
"Replacing the Toner Cartridge, " on p. 9-13.)
TOP
Previous
Next
10-32