Database Mode - Omron V440-F User Manual

Appendices
L-5

Database Mode

L-5-1 Switch Mode
Selects the event that causes the reader to load the next database entry to
Definition:
current, active settings. When Frame Count/Time expires and Image Process
Looping is enabled, the next database entry with modifications to reader
settings will be used.
Note: The image capture event always occurs when the first database entry
is used.
Note: The Switch Mode setting has no effect on Rapid Capture Mode,
which always operates in Number of Image Frames mode with a frame
count of 1.
Serial Cmd: <K256,switch mode,frame count/time,image process looping,image dimensions>
Default: 1
0 = Time
Options:
Time
When Switch Mode is set to Time, the reader will load the next database entry to current, active set-
tings after a predefined time interval. The timer will start upon use of a database entry. If the timer
expires during an image capture event, the timer will not start again until that database entry has been
incremented and the new database entry has been loaded to current, active settings.
Number of Image Frames
When Switch Mode is set to Number of Image Frames, the database entry is incremented after the pre-
determined number of image capture events has occurred.
L-5-2 Frame Count/Time
Indicates the Number of Image Frames that must be captured or the
Definition:
amount of Time that must transpire before the reader will load the next
database index entry.
Serial Cmd: <K256,switch mode,frame count/time,image process looping,image dimensions>
1 (frames or ms)
Default:
1 to 65535
Options:
L-5-3 Image Process Looping
Useful in applications where it is necessary to process a single captured
Usage:
image multiple times using different IP and decode parameters.
Serial Cmd: <K256,switch mode,frame count/time,image process looping,image dimensions>
Default: 1
Options: 0 = Disabled
L-10
1 = Number of Image Frames
1 = Enabled
V440-F C-Mount Code Reader User Manual