New Master Pin - Omron V440-F User Manual

Appendices
J-7

New Master Pin

Definition:
Serial Cmd:
Default:
Options:
J-7-1 New Master Load Status
Definition:
Serial Cmd:
J-10
If Matchcode and New Master Pin are enabled and the new master pin
is momentarily activated (must be active for a minimum of 10 ms) master
symbol information will be loaded into the database based on the next
read cycle that achieves a Good Read, starting with Index 1.
Note: For the V440-F, Input 1 (pin 3) is Default and Input 2 (pin 4) is New
Master.
<K225,status>
Disabled
0 = Disabled
The new master status responds with the number of the next master
position to be loaded, where 0 represents "idle" or "no master to be
loaded."
Example: If the user has the Number of Master Symbols set to 1, and
then either sends a <G> or toggles an active New Master Pin, the state
will be 1, and prior to reading and effectively loading position 1, the
response to <NEWM> would be <NEWM/1>. Once a symbol has been
read and loaded, the status will be cleared: <NEWM/0>.
<NEWM>
1 = Enabled
V440-F C-Mount Code Reader User Manual