Set (Setting) Mode; Menu Registration - Omron V530-C300E Operation Manual

SET (Setting) Mode

5-1

SET (Setting) Mode

5-1-1

Menu Registration

Menu
QR Code (Normal)
QR Code (Pattern)
Data Matrix (Normal)
Data Matrix (Pattern)
46
The V530-C300E has the four reading modes shown below. Choose
the mode that is appropriate for the type of code and the conditions in
which it is to be read.
This mode can normally be used for QR
Code reading.
Try this mode when reading codes of poor
marking quality or codes made up of dots, or
any other codes for which stable reading is
not possible. Images of finder patterns (the
symbols in 3 of the corners) are registered,
and the position of codes is determined by
searching for these images.
Note This mode has an orientation tolerance
of ±10°. Reading is not possible for
orientations greater than this.
This mode can normally be used for
Data Matrix reading.
Try using this mode when reading codes
of poor marking quality or codes made up
of dots, or in any other situation where
stable reading is not possible. An image
of the finder pattern (the L-shape
described by 3 of the corners) is
registered, and the position of codes is
determined by searching for this image.
Note 1: This menu has an orientation tolerance of ±10°.
Reading is not possible for orientations greater
than this.
Note 2: Adjust the code size so there are at least 10 pixels
per cell and there is a margin of at least 2 pixels
around the code.
Contents
Section 5-1