Read Cycle Setup - Omron V440-F User Manual

F-2

Read Cycle Setup

Setting up read cycle and triggering parameters will involve a series of decisions based on your
particular application, as follows:
1
Select the number of symbols to be read in a single cycle. The reader can read multiple symbols
in a single image frame and/or spread over multiple frames.
2
Decide on the trigger type to be used: if serial, choose a serial character; if external, choose
either Level or Edge.
3
Designate how the read cycle should end (Timeout, New Trigger, Last Frame).
4
Select Capture Mode between Continuous Mode or Rapid Mode.
5
Select Number of Captures (if in Rapid Capture Mode).
6
Set the Time Before First Capture and Time Between Captures if Rapid Mode is used. This
is to maintain processing backlog (tuning – depending on total read cycle time and object rate
of motion).
Note: The capture rate increases as the frame size decreases.
V440-F C-Mount Code Reader User Manual
Appendices
F
F-3