ABB Relion 650 Series Applications Manual page 183

1MRK 505 287-UUS B
10.7.3 Setting guidelines
The parameters for the single point generic control 8 signals (SPC8GGIO) function are set via the
local HMI or PCM600.
Operation : turning the function operation Enabled / Disabled .
There are two settings for every command output (totally 8):
Latchedx : decides if the command signal for output x is Latched (steady) or Pulsed .
tPulsex : if Latchedx is set to Pulsed , then tPulsex will set the length of the pulse (in seconds).
10.8 Automation bits AUTOBITS
10.8.1 Identification
Function description
AutomationBits, command function
10.8.2 Application
The AUTOBITS function block (or the automation bits function block) is used within PCM600 in
order to get into the configuration the commands coming through the DNP3 protocol.AUTOBITS
function block have 32 individual outputs which each can be mapped as a Binary Output point in
DNP3. The output is operated by a "Object 12" in DNP3. This object contains parameters for
control-code, count, on-time and off-time. To operate an AUTOBITS output point, send a control-
code of latch-On, latch-Off, pulse-On, pulse-Off, Trip or Close. The remaining parameters are
regarded as appropriate. For example, pulse-On, on-time=100, off-time=300, count=5 would give 5
positive 100 ms pulses, 300 ms apart.
See the communication protocol manual for a detailed description of the DNP3 protocol
10.8.3 Setting guidelines
AUTOBITS function block has one setting, (
function. These names will be seen in the DNP communication configuration tool in PCM600.
Busbar protection REB650
Application manual
IEC 61850
identification
for DNP3
© Copyright 2013 ABB. All rights reserved
IEC 60617
identification
AUTOBITS -
Operation : Enabled / Disabled ) enabling or disabling the
GUID-C3BB63F5-F0E7-4B00-AF0F-917ECF87B016 v3
ANSI/IEEE C37.2
device number
-
Section 10
Control
SEMOD176518-4 v4
SEMOD158637-5 v4
SEMOD158639-5 v3
177