ABB Relion 650 Series Applications Manual page 136

Section 10
Control
QCBAY
ANSI10000198 V2 EN-US
Figure 49: Signal flow between apparatus control function blocks
Accepted originator categories for PSTO
If the requested command is accepted due to the authority allocation control, the respective value
will change. Otherwise the attribute
PSTO value is changed under a command, then the command is reset.
The accepted originator categories for each PSTO value are shown in
Table 15:
PermittdSourceToOperate
0 = Off
1 = Local
2 = Remote
Table continues on next page
130
SCSWI
SCILO
(3)
SCSWI
SCILO
(3)
The IEC 61850 communication has always priority over binary inputs, e.g. a block
command on binary inputs will not prevent commands over IEC 61850.
Accepted originator categories for each PSTO
© Copyright 2013 ABB. All rights reserved
IEC 61850
SXCBR
SXSWI
blocked-by-switcing-hierarky is set in the cause signal. If the
Originator
4,5,6
1,4,5,6
2,3,4,5,6
1MRK 505 287-UUS B
-189
-BKR1
52
-989
ANSI10000198_2_en.vsd
Table 15
Busbar protection REB650
Application manual