ABB Relion 650 Series Applications Manual page 181

1MRK 505 287-UUS B
10.5 Selector mini switch VSGGIO
10.5.1 Identification
Function description
Selector mini switch
10.5.2 Application
Selector mini switch (VSGGIO) function is a multipurpose function used in the configuration tool in
PCM600 for a variety of applications, as a general purpose switch. VSGGIO can be used for both
acquiring an external switch position (through the IPOS1 and the IPOS2 inputs) and represent it
through the single line diagram symbols (or use it in the configuration through the outputs POS1
and POS2) as well as, a command function (controlled by the PSTO input), giving switching
commands through the CMDPOS12 and CMDPOS21 outputs.
The output POSITION is an integer output, showing the actual position as an integer number 0 – 3.
An example where VSGGIO is configured to switch Autorecloser enabled–disabled from a button
symbol on the local HMI is shown in
normally used for enable–disable operations of the circuit breaker.
INTONE
Disabled
Enabled
ANSI07000112 V2 EN-US
Figure 94: Control of Autorecloser from local HMI through Selector mini switch
10.5.3 Setting guidelines
Selector mini switch (VSGGIO) function can generate pulsed or steady commands (by setting the
Mode parameter). When pulsed commands are generated, the length of the pulse can be set using
tPulse parameter. Also, being accessible on the single line diagram (SLD), this function block
the
has two control modes (settable through
Busbar protection REB650
Application manual
IEC 61850
identification
VSGGIO
figure
VSGGIO
PSTO
IPOS1
IPOS2
NAM_POS1
CMDPOS12
NAM_POS2 CMDPOS21
© Copyright 2013 ABB. All rights reserved
IEC 60617
identification
-
94. The Close and Open buttons on the local HMI are
OUT
SMBRREC_79
ON
OFF
IEC07000112-2-en_ansi.vsd
CtlModel ): Dir Norm and SBO Enh .
ANSI/IEEE C37.2
device number
-
INV
INPUT
SETON
Section 10
Control
SEMOD167850-2 v2
SEMOD158803-5 v5
SEMOD158807-4 v3
175