At/Atx Mode Selection; Mounting The System; Figure 3-8: Clear Cmos Button Location; Figure 3-9: At/Atx Switch Location - IEI Technology DRPC-120-BTi User Manual

DRPC-120-BTi Embedded System

Figure 3-8: Clear CMOS Button Location

3.7 AT/ATX Mode Selection

AT and ATX power modes can both be used on the DRPC-120-BTi. The selection is made
through an AT/ATX switch on the top panel as shown below (Figure 3-9).

Figure 3-9: AT/ATX Switch Location

3.8 Mounting the System

The DRPC-120-BTi embedded system can be mounted onto a DIN rail. Follow the steps
below to complete the task.
Step 1: Attach the supplied DIN rail mounting bracket to the rear panel of the embedded
system. Secure the bracket to the embedded system with three retention screws
(Figure 3-10).
Page 23