Table of Contents
Advertisement
3.3 HDD Installation
WARNING:
Please install a solid state drive (SSD) when the DRPC-120-BTi is
used in a harsh environment with extreme shock and vibration.
The DRPC-120-BTi allows installation of one 2.5" HDD/SSD. To install a HDD into the
system, please follow the steps below.
Step 1:
Remove the internal access panel from the DRPC-120-BTi. Please follow the
instruction described in Section 3.2.
Step 2:
Install the HDD into the bracket on the internal access panel, and secure the
HDD with four retention screws (Figure 3-2).
Step 3:
Connect the SATA cable and the SATA power cable to the rear of the HDD
(Figure 3-2).
Step 4:
Connect the SATA cable and the SATA power cable from the HDD to the SATA
connector and SATA power connector on the motherboard (Figure 3-2).
Figure 3-2: HDD Installation
Step 5:
Replace and secure the internal access panel to the system.
Page 18
DRPC-120-BTi Embedded System
Advertisement
Table of Contents
