3� 5� 3� Pre-Selecting The Rcf-Value; 3� 5� 4� Pre-Selecting Run Time - Fisher Scientific Fisherbrand accuSpin Micro Series Instruction Manual

3. 5. 3. Pre-selecting the RCF-Value
1. Enter the desired value by pressing the MINUS / PLUS buttons
the desired value shows. You can adjust the RCF pre-selected value in steps of 100
x g.
2. Press START to confirm the pre-selected value.
If you do not press any button, the display flashes for a few seconds. The new
preselected value is now stored and the display shows the actual value.
NOTICE The RCF value can be set to a minimum of 100 x g. The maximum speed depends on the
centrifuge variant. The displayed RCF value is always corresponding to the maximum of centrifuge
radius of the 24 x 1.5 / 2.0 mL Rotor (75003424). Refer to
further information.
NOTICE Avoid if possible speed ranges close to natural resonances of the system. Runs at
resonance speeds may cause vibration and have an adverse effect on the quality of separation.
3. 5. 4. Pre-selecting Run Time
NOTICE You can select a run time between 1 and 99 min or continuous operation.
1. Enter the desired value by pressing the MINUS / PLUS buttons
in the middle repeatedly, until the desired value shows. You can adjust the run time in
steps of 1 min.
2. Press START to confirm the pre-selected value.
If you do not press any key, the display flashes for a few seconds. The new preselected
value is now stored and the display shows the actual value.
TIME
Operation
"RCF Value Explained" on page 46
48 / 89
repeatedly, until
for
below the display