3� 2� Power On / Off; 3� 2� 1� To Power On The Centrifuge; 3� 2� 2� To Power Off The Centrifuge; 3� 2� 3� Audible Alarm - Fisher Scientific Fisherbrand accuSpin Micro Series Instruction Manual

3. 2. Power on / off
3. 2. 1. To power on the centrifuge
Push on the mains switch of the centrifuge to "1" to power it on.
The centrifuge shows the actual value in the display. Speed and Time show 0. The display
shows the current temperature of the sample.
3. 2. 2. To power off the centrifuge
Set the mains switch of the centrifuge to "0" to power it off.
NOTICE The centrifuge is equipped with a special switch for balancing potential voltage
discrepancies in the power grid. After pressing the mains switch the display therefore may still
flash up to 10 seconds.
3. 2. 3. Audible Alarm
Error
Accompanying all error messages, a warning signal is given out.
Press any key to silence the warning signal.
End of Run
By default there is an acoustic signal at the end of any centrifugation run. To switch off this
signal proceed as follows:
1. Keep the TOGGLE button
The display shows:
SPEED
or
SPEED
Operation
pressed when you turn on the centrifuge.
X G
RPM
XG RPM TIME
PULSE OPEN
X G
RPM
START STOP
XG RPM TIME
PULSE OPEN
38 / 89
TEMP COOL
TEMP COOL