Servo Amplifier Standard Specifications - Mitsubishi Electric MR-J3-10B Instruction Manual

1. FUNCTIONS AND CONFIGURATION

1.3 Servo amplifier standard specifications

Item
Voltage/frequency
Permissible voltage fluctuation
Permissible frequency fluctuation
Power supply capacity
Inrush current
www.DataSheet4U.com
Control circuit
power supply
Interface power
supply
Control System
Dynamic brake
Protective functions
Structure
Ambient
temperature
Ambient
humidity
Ambient
Altitude
Vibration
Mass
Note 1. 150mA is the value applicable when all I/O signals are used. The current capacity can be decreased by reducing the number of
I/O points.
2. When mounting the servo amplifiers closely, operate them at the ambient temperatures of 0 to 45
effective load ratio.
Servo Amplifier
MR-J3- 10B
3-phase 200 to 230VAC,
50/60Hz or 1-phase 230VAC,
3-phase 200 to 230VAC: 170
1-phase 230VAC: 207 to
Voltage, frequency
Permissible voltage
fluctuation
Permissible frequency
fluctuation
Input
Inrush current
Voltage, frequency
Power supply capacity
Overcurrent shut-off, regenerative overvoltage shut-off, overload shut-off (electronic thermal
relay), servo motor overheat protection, encoder error protection, regenerative brake error
protection, undervoltage, instantaneous power failure protection, overspeed protection,
excessive error protection
Self-cooled, open
[ ] (Note 2) 0 to 55 (non-freezing)
During
operation
[ ] 32 to 131 (non-freezing)
[ ] 20 to 65 (non-freezing)
In storage
[ ] 4 to 149 (non-freezing)
In operation
90%RH or less (non-condensing)
In storage
Indoors (no direct sunlight)
Free from corrosive gas, flammable gas, oil mist, dust and dirt
Max. 1000m (3280ft) above sea level
5.9 [m/s
[kg] 0.8
[lb] 1.8
20B 40B 70B 100B
3-phase 200 to 230VAC, 50/60Hz
50/60Hz
to 253VAC
3-phase 170 to 253VAC
253VAC
Refer to Section 10.2
Refer to Section 10.5
1-phase 200 to 230VAC, 50/60Hz
1-phase 170 to 253VAC
30W
Refer to Section 11.5
(Note 1) 150mA or more
Sine-wave PWM control, current control system
Force-cooling, open (IP00)
(IP00)
2
] or less
0.8 1.0 1.4 1.4
1.8 2.2 3.1 3.1
1 - 4
200B 350B 500B 700B 10B1
1-phase 85 to 132VAC
Within 5%
1-phase 85 to 132VAC
Within 5%
45W
DC24V 10%
Built-in
2.3 2.3 4.6 6.2
5.071 5.071 10.1 13.7
or at 75% or a smaller
20B1 40B1
1-phase 100V to
120VAC, 50/60Hz
1-phase 100 to
120VAC, 50/60Hz
30W
Self-cooled, open
(IP00)
0.8 0.8 1.0
1.8 1.8 2.2