Startup - Mitsubishi Electric MR-J3-10B Instruction Manual

4. STARTUP

4.1.2 Wiring check
(1) Power supply system wiring
Before switching on the main circuit and control circuit power supplies, check the following items.
(a) Power supply system wiring
The power supplied to the power input terminals (L
the defined specifications. (Refer to Section 1.3.)
(b) Connection of servo amplifier and servo motor
1) The servo motor power supply terminals (U, V, W) of the servo amplifier match in phase with the
power input terminals (U, V, W) of the servo motor.
www.DataSheet4U.com
2) The power supplied to the servo amplifier should not be connected to the servo motor power supply
terminals (U, V, W). To do so will fail the connected servo amplifier and servo motor.
3) The earth terminal of the servo motor is connected to the PE terminal of the servo amplifier.
4) P -P
1
(c) When option and auxiliary equipment are used
1) When regenerative brake option is used under 3.5kW
The lead between P terminal and D terminal of CNP2 connector should not be connected.
The generative brake option should be connected to P terminal and C terminal.
A twisted cable should be used. (Refer to Section 11.2)
should be connected.
2
, L , L , L
1 2 3 11
Servo amplifier Servo motor
U
U
V
V
W
W
Servo amplifier
U V W
Servo amplifier Servo motor
Servo amplifier
P
1
P
2
4 - 2
, L ) of the servo amplifier should satisfy
21
M
Servo motor
M
U V W
M