Mitsubishi Electric MR-J3-10B Instruction Manual page 53

3. SIGNALS AND WIRING
(b) Termination of the cables
1) CNP1 CNP3
Solid wire: After the sheath has been stripped, the cable can be used as it is.
Twisted wire: Use the cable after stripping the sheath and twisting the core. At this time, take care to avoid
www.DataSheet4U.com
2) CNP2
CNP2 is the same as MR-J3-100B or smaller capacities. Refer to (1) (b) in this section.
(c) As twin type connector for CNP2 (L
Refer to (1) (C) in this section.
a short caused by the loose wires of the core and the adjacent pole. Do not solder the core as
it may cause a contact fault. Alternatively, a bar terminal may be used to put the wires
together.
Cable size
2
[mm ] AWG For 1 cable
0.34 22 AI0.34-8TQ
0.5 20 AI0.5-8WH
0.75 18 AI0.75-8GY
1 18 AI1-8RD
1.5 16 AI1.5-8BK
2.5 14 AI2.5-8BU
11
Sheath
Core
7mm
(0.276in)
Bar terminal type
For 2 cables
AI-TWIN2 0.5-8WH
AI-TWIN2 0.75-8GY
AI-TWIN2 1-8RD
AI-TWIN2 1.5-8BK
AI-TWIN2 2.5-8BU
, L ) is the same as MR-J3-100B or smaller.
21
3 - 12
Crimping tool Maker
CRIMPFOX-ZA3 Phoenix Contact