List Of Details - Mitsubishi Electric MR-J3-10B Instruction Manual

5. PARAMETERS

5.4.2 List of details

No. Symbol
PD01
PD02
PD03
PD04
PD05
PD06
PD07 *DO1
www.DataSheet4U.com
PD08 *DO2
PD09 *DO3
For manufacturer setting
Do not change this value by any means.
Output signal device selection 1 (CN3-13)
Any input signal can be assigned to the CN3-13 pin.
Note that the signal that can be assigned change depending on the control mode.
0 0 0
Select the output device of the CN3-13 pin.
The devices that can be assigned in each control mode are those that have the symbols
indicated in the following table. If any other device is set, it is invalid.
Setting Device
00 Always OFF
For manufacturer
01
setting (Note 3)
02 RD
03 ALM
04 INP (Note 1)
05 MBR
06 DB
07 TLC
08 WNG
09 BWNG
Note 1. It becames always OFF in speed control mode.
Note 2. It becames SA in speed control mode.
Note 3. For manufacturer setting
Never change this setting.
Output signal device selection 2 (CN3-9)
Any input signal can be assigned to the CN3-9 pin.
The devices that can be assigned and the setting method are the same as in parameter
No. PD07.
0 0 0
Select the output device of the CN3-9 pin.
Output signal device selection 3 (CN3-15)
Any input signal can be assigned to the CN3-15 pin.
The devices that can be assigned and the setting method are the same as in parameter
No. PD07.
0 0 0
Select the output device of the CN3-15 pin.
Name and Function
Setting Device
0A Always OFF (Note 2)
For manufacturer
0B
setting (Note 3)
0C ZSP
For manufacturer
0D
setting (Note 3)
For manufacturer
0E
setting (Note 3)
0F CDPS
For manufacturer
10
setting (Note 3)
11 ABSV (Note 1)
For manufacturer
12 to 1F
setting (Note 3)
For manufacturer
20 to 3F
setting (Note 3)
5 - 25
Initial Setting
Unit
Value Range
0000h
0000h
0000h
0000h
0000h
0000h
0005h Refer to
Name
and
function
column.
0004h Refer to
Name
and
function
column.
0003h Refer to
Name
and
function
column.