Cpci I/O Signals; J3 Signal Specification; Ethernet Leds; Ethernet 1 - Kontron CPCI-MXS Technical Reference Manual

5. To engage the board's connectors into the backplane connector, press
simultaneously on the front plate.
6. Fasten the module using the fellow-plate fixing screw to secure the module to the
system chassis.
To remove the module from the chassis, proceed as follows:
1. Remove the front plate fixing screws.
2. Press the handle to act as a lever to disengage the CompactPCI connector from the
backplane.
3. Pull on the handle and gently remove the board.

3.5. cPCI I/O SIGNALS

This section describes integrated feature signals available on rear panel cPCI I/O
connectors (J3, J4, and J5)

3.5.1 J3 Signal Specification

3.5.1.1.

Ethernet LEDs

Signal Pin Assignation
LAN0, 1: SPLED
A6, E6
LAN0, 1: LINKLED
B6, D6
LAN0, 1:ACTLED
C6, A7
3.5.1.2.

Ethernet 1

Signal Pin Assignation
LAN1:ETX+ A9
LAN1:ETX- B9
LAN1:ERX+ C9
LAN1:ERX- D9
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description
Speed LED signal
Link integrity LED signal
Transmit / receive activity LED signal
Description
Ethernet High Transmit Data line
Ethernet Low Transmit Data line
Ethernet High Receive Data line
Ethernet Low Receive Data line
3-29
Installing the Board