Onboard Connectors And Headers - Kontron CPCI-MXS Technical Reference Manual

3.2.6 Onboard Connectors and Headers

Connect
Description
CompactPCI Bus J1/J2
CompactPCI I/O
CompactPCI I/O J4/J5
DIMM Sockets J6, J7, J8
Processor Socket
VGA
Serial Port 1
Kontron's
J14, J19
Mezzanine
Ethernet 1, 2 J16/J15
Keyboard/Mouse
CompactFlash
Storage Mezzanine
PMC J20, J21
Battery BT1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
or
J1- cPCI bus signals and power.
J2 – Additional system slot signals.
J3 Serial Ports 3 and 4, Ethernet 1, power.
Supports PS/2 mouse, serial ports 1 and 2, first IDE
channel, parallel port, keyboard, speaker, floppy
disk, reset, USB, SMBus, and power signals.
Supports 168-pin 64/72-bit DIMMs, up to 768MB of
RAM.
J9
MXS64 : Mobile Pentium II / III connector
J12 Supports standard 15-pin DSUB female connector.
J13 Supports standard 9-pin DSUB male connector.
This connector handles PCI bus signals to the mezzanine.
RJ-45 connectors with built-in activity and link
indicators.
Mouse and keyboard signals are combined on a
J17
standard 6-pin DSUB female connector.
This connector is dedicated to the Kontron's
J18
CompactFlash module to support CompactFlash disk.
This connector is implemented to support floppy drive
J19
and hard disk signals.
The PCI Mezzanine Card (PMC) connectors support one
standard PMC device.
CMOS backup battery connector.
3-11
Installing the Board
Comments