Figure 3-19: Drill Pilot Holes For V-Stand; Figure 3-20: Secure V-Stand To System - IEI Technology AFL3-W07A-AL User Manual

Figure 3-19: Drill Pilot Holes for V-Stand

Step 2:
Align the screw holes on the V-Stand with the VESA mount screw holes on the
system rear panel.
Step 3: Insert the four VESA mount screws into the four screw holes on the system rear
panel. Adjust the V-Stand to a proper position.
Step 4: Tighten until the screw shank is secured against the rear panel.

Figure 3-20: Secure V-Stand to System

Page 32
AFL3-W07A-AL Panel PC