Powering On The System; Figure 3-21: Secure V-Stand To Mounting Area - IEI Technology AFL3-W07A-AL User Manual

AFL3-W07A-AL Panel PC
Step 5: Align the V-Stand screw holes with the pilot holes on the mounting area. Mount
the V-Stand by inserting the retention screws into the four pilot holes and
tightening them.
Step 6: Adjust the V-Stand to have a best viewing angle to operate the

Figure 3-21: Secure V-Stand to Mounting Area

3.7 Powering On the System

To power on the system, follow the steps below:
Step 1:
Connect the power cord to the power adapter. Connect the other end of the
power cord to a power source.
Step 2: Connect the power adapter to the power connector of the AFL3-W07A-AL.
Step 3:
Locate the power button on the I/O panel.
Step 4:
Hold down the power button until the power LED on the front panel turns on in
green. Step 0:
system.S t e p 0 :
Page 33