Figure 3-16: Arm Mounting Retention Screw Holes - IEI Technology AFL3-W07A-AL User Manual

AFL3-W07A-AL Panel PC
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 75 mm interface pad. If the mounting arm is not VESA
compliant it cannot be used to support the AFL3-W07A-AL flat bezel panel
PC.
Step 2:
Once the mounting arm has been firmly attached to the surface, lift the flat bezel
panel PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
flat bezel panel PC (Figure 3-16).

Figure 3-16: Arm Mounting Retention Screw Holes

Step 4: Secure the AFL3-W07A-AL to the interface pad by inserting four retention
screws through the mounting arm interface pad and into the AFL3-W07A-AL.S t e p 0 :
Page 29