Figure 3-10: Panel Mounting Kit Installation - IEI Technology AFL3-W07A-AL User Manual

AFL3-W07A-AL Panel PC
Step 3: Slide the flat bezel panel PC through the hole until the frame is flush against the
panel.
Step 4: Insert a M5*50 screw into the screw hole on the side of the panel mounting
bracket. Then, install the following components onto the screw in sequence.
See Figure 3-10.
Sequence
1
2
3
Step 5: Repeat Step 4
mounting brackets.

Figure 3-10: Panel Mounting Kit Installation

Item Photo
Spring
Nut
Plastic
cap
to install the other three screws into the sides of the two panel
Instruction
Install a spring onto the screw.
Tighten a nut until the spring is
compressed enough for plastic cap.
Tighten a plastic cap onto the end of
screw thread.
Page 23