Enter Setup
Custom Prefix
Enable/Disable Custom Prefix
If custom prefix is enabled, you are allowed to append to the data a user-defined prefix that cannot exceed
10 characters.
Enable Custom Prefix
Set Custom Prefix
To set this parameter, scan the Set Custom Prefix barcode, the numeric barcodes corresponding to the
hexadecimal value of a desired prefix, and the Save barcode.
Note: A custom prefix cannot exceed 10 characters.
Example: Set the custom prefix to "CODE"
Check the hex values of "CODE" in the ASCII Table. ("CODE": 43, 4F, 44, 45)
1.
2.
Scan the Enter Setup barcode.
3.
Scan the Set Custom Prefix barcode.
Scan the numeric barcodes "4", "3", "4", "F", "4", "4", "4" and "5". (See the Digit Barcodes)
4.
5.
Scan the Save barcode. (See the Save/Cancel Barcodes)
6.
Scan the Exit Setup barcode.
Exit Setup
**
Set Custom Prefix
**
Disable Custom Prefix
40