** Enter Setup
Custom Prefix
Enable/Disable Custom Prefix
If custom prefix is enabled, you are allowed to append to the data a user-defined prefix that cannot
exceed 5 characters.
For example, if barcode data is "123" and custom prefix is "AB", the Host will receive "AB123".
Enable Custom Prefix
Set Custom Prefix
To set a custom prefix, scan the Set Custom Prefix barcode, the numeric barcodes corresponding to the
hexadecimal value of a desired prefix and the Save barcode.
Note: A custom prefix cannot exceed 5 characters.
Example: Set the custom prefix to "CODE" (its hexadecimal value is 0x43/0x4F/0x44/0x45)
1.
Scan the Enter Setup barcode.
2.
Scan the Set Custom Prefix barcode.
Scan the numeric barcodes "4","3","4","F","4","4","4" and "5". (See the Digit Barcodessection in
3.
Appendix)
4.
Scan the Save barcode. (See the Save/Cancel Barcodes section in Appendix)
5.
Scan the Enable Custom Prefix barcode.
6.
Scan the Exit Setup barcode.
Exit Setup
Set Custom Prefix
** Disable Custom Prefix
82