Table of Contents
Advertisement
Enter Setup
Custom Prefix
Enable/Disable Custom Prefix
If custom prefix is enabled, you are allowed to append to the data a user-defined prefix that cannot exceed 10 characters.
For example, if the custom prefix is "AB" and the barcode data is "123", the Host will receive "AB123".
** Disable Custom Prefix
Set Custom Prefix
To set a custom prefix, scan the Set Custom Prefix barcode then the numeric barcodes corresponding to the hexadecimal
value of a desired prefix then the Save barcode.
Note: A custom prefix cannot exceed 10 characters.
Set the custom prefix to "CODE" (HEX: 0x43/0x4F/0x44/0x45):
1.
2.
3.
4.
5.
6.
** Exit Setup
Scan the Enter Setup barcode.
Scan the Set Custom Prefix barcode.
Scan the numeric barcodes "4", "3", "4", "F", "4", "4", "4" and "5" from the "Digit Barcodes" section in
Appendix.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
Scan the Enable Custom Prefix barcode.
Scan the Exit Setup barcode.
Set Custom Prefix
Enable Custom Prefix
192
Advertisement
Table of Contents
