Custom Suffix
Enable/Disable Custom Suffix
If custom suffix is enabled, you are allowed to append to the data a user-defined suffix that cannot
exceed 10 characters.
Enable Custom Suffix
Set Custom Suffix
To set this parameter, scan the Set Custom Suffix barcode, the numeric barcodes corresponding to the
hexadecimal value of a desired prefix, and the Save barcode.
Note: A custom suffix cannot exceed 10 characters.
Example: Set the custom suffix to "CODE"
Check the hex values of "CODE" in the ASCII Table. ("CODE": 43, 4F, 44, 45)
1.
2.
Scan the Enter Setup barcode.
3.
Scan the Set Custom Suffix barcode.
Scan the numeric barcodes "4", "3", "4", "F", "4", "4", "4" and "5". (See the Digit Barcodes)
4.
5.
Scan the Save barcode. (See the Save/Cancel Barcodes)
6.
Scan the Exit Setup barcode.
41
Set Custom Suffix
**
Disable Custom Suffix
Enter Setup
**Exit Setup