Custom Prefix; Enable/Disable Custom Prefix; Set Custom Prefix - Newland NLS-HR15-BT User Manual

Custom Prefix

Enable/Disable Custom Prefix

If custom prefix is enabled, you are allowed to append to the data a user-defined prefix that cannot exceed 10 characters.
For example, if the custom prefix is "AB" and the barcode data is "123", the Host will receive "AB123".
** Disable Custom Prefix

Set Custom Prefix

To set a custom prefix, scan the Set Custom Prefix barcode then the numeric barcodes corresponding to the hexadecimal
value of a desired prefix then the Save barcode.
Note: A custom prefix cannot exceed 10 characters.
Set the custom prefix to "CODE" (HEX: 0x43/0x4F/0x44/0x45):
1. Scan the Enter Setup barcode.
2. Scan the Set Custom Prefix barcode.
3. Scan the numeric barcodes "4", "3", "4", "F", "4", "4", "4" and "5" from the "Digit Barcodes" section in
Appendix.
4. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
5. Scan the Enable Custom Prefix barcode.
6. Scan the Exit Setup barcode.
241
Set Custom Prefix
Enter Setup
Enable Custom Prefix
** Exit Setup