【Enter Setup】
Custom Prefix
Enable/Disable Custom Prefix
If custom prefix is enabled, you are allowed to append to the data a user-defined prefix that cannot
exceed 10 characters. For example, if the custom prefix is "AB" and the barcode data is "123", the Host
will receive "AB123".
**【Disable Custom Prefix】
Set Custom Prefix
To set a custom prefix, scan the Set Custom Prefix barcode and then the numeric barcodes
corresponding to the hexadecimal value of a desired prefix. To save the settings, scan the Save barcode.
Note: A custom prefix cannot exceed 10 characters.
Set the custom prefix to "CODE" (its hexadecimal value is 0x43/0x4F/0x44/0x45):
**【Exit Setup】
【Set Custom Prefix】
1. Scan the Enter Setup barcode.
2. Scan the Set Custom Prefix barcode.
3. Scan the numeric barcodes "4","3","4","F","4","4","4" and "5". (See the Digit
Barcodes in Appendix)
4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)
5. Scan the Enable Custom Prefix barcode.
6. Scan the Exit Setup barcode.
【Enable Custom Prefix】
124