Enter Setup
Specify Central Area
The default central area is a (Width*20%) by (Height*20%) area in the center of the engine's field of view,
as shown in the figure below. You can define the central area by scanning the Specify Central Area
barcode and numeric barcode(s) corresponding to a desired percentage (1-100). If Central Area Decoding
is enabled by scanning the Central Area Decoding barcode, the engine only reads barcodes that
intersect the predefined central area.
To learn how to program this parameter, see the c. Program the Central Area in Appendix 8.
Specify Central Area
25
**Exit Setup