Erase Pin Codes; Erase Rfid Tag - Tele Radio TIGER G2 Installation Instructions Manual

5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
6. Go to [Learn RFID].
7. Select the position in the list where you want the new RFID tag to be stored by pressing the left start
button.
8. Confirm by pressing the left start button.
9. The display shows [Show RFID tag].
10. Press the RFID tag against the RFID antenna above the stop button on the front of the transmitter.
11. If the tag is accepted, the buzzer beeps 2 times. The transmitter turns off.
If the RFID tag is not accepted, the transmitter will turn off after 10 seconds.

ERASE PIN CODES

1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.The LEDs light (green when the battery capacity is good, red when
the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The LEDs light (green when the battery capacity is good, red when the battery capacity is poor) when in
menu mode.
6. Go to [PIN] --> [Erase PIN].
7. Scroll the list to select the PIN code that you want to erase.
8. Select by pressing the left start button.
9. Confirm by pressing the left start button.

ERASE RFID TAG

1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
- 46 -