Chapter 4: Installers Guide; Navigate In Menu Mode; Enable Rfid And Pin Codes - Tele Radio TIGER G2 Installation Instructions Manual

Chapter 4: INSTALLERS GUIDE

CHAPTER 4: INSTALLERS GUIDE

NAVIGATE IN MENU MODE

To navigate when in menu mode:
Press...
Button 1
Button 2
Button 3
Button 4
The left start button
The right start button

ENABLE RFID AND PIN CODES

1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
6. Go to [Startup Protect.].
7. Select one or more start-up protection choices by pressing the left start button.
Select...
[Stored PIN]
[Any PIN]
[Any keyring]
[Any walltag]
[Stored RFID]
[Allow skip]
8. Confirm by pressing the left start button.
to...
Step down
Step up
Step left/ go back
Step right
Select/ confirm
Exit
to...
Only PIN codes registered in the transmitter will
be accepted
Any PIN code will be accepted
Any Tele Radio keyring tag will be accepted
Any Tele Radio wall tag will be accepted
Only stored RFID keyring tags or wall tags will be
accepted
Allows to skip any start-up authorization
- 44 -