Appendix2 Error Codes Stored By The Pcpu - Mitsubishi Electric SV13/22 Programming Manual

APPENDICES

APPENDIX2 ERROR CODES STORED BY THE PCPU

Downloaded from ManualsNet.com
The errors that are detected at the PCPU are servo program setting errors and
positioning errors.
(1) Servo program setting errors
Servo program setting errors are errors in the positioning data set in the servo
program and are checked for when a servo program is started.
They are errors that occur when the positioning data is designated indirectly.
When a servo program setting error occurs, the following happens:
• The servo program setting error flag (M9079) comes ON.
• The program number of the program in which the error occurred is stored in
the error program No. register (D9189).
• The error code is stored in the error item information register (D9190).
(2) Positioning error
(a) Positioning errors are errors that occur when positioning starts or during
positioning: they are classified into minor errors, major errors, and servo
errors.
1) Minor errors ............. These are errors generated by sequence programs
2) Major error............... These are errors generated by external input signals
3) Servo error .............. These are errors detected by the servo amplifier;
(b) When an error occurs, the error detection signal for the relevant axis comes
ON, and the error code is stored in the minor error code, major error code,
or servo error code register.
<A171SHCPUN> Table 2.1 Error Code Registers, Error Detection Flags
Device
Error
Class
Minor error
Major error
Servo error
search engine
or servo programs; they are assigned error codes 1
to 999.
The cause of minor errors can be eliminated by
checking the error code and correcting the
sequence program or servo program.
or control commands from the SCPU; they are
assigned error codes 1000 to 1999.
When a major error occurs, check the error code
and eliminate the error cause in the external input
signal status or sequence program.
they are assigned error codes 2000 to 2999.
When a servo error occurs, check the error code
and eliminate the error cause at the servo side.
Error Code Register
Axis 1 Axis 2
D806 D826
D807 D827
D808 D828
APP − 5
Error Detection
Axis 3 Axis 4
D846 D866
M1607+20n
D847 D867
D848 D868 M1608+20n
Signal