Arp Inspection Port Configure - ZyXEL Communications GS2220 Series User Manual

Table 129 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure (continued)
L ABEL
Apply
Cancel
28.2.1 ARP Inspe c tio n Po rt C o nfig ure
Use this screen to specify whether ports are trusted or untrusted ports for ARP inspection. You can also
specify the maximum rate at which the Switch receives ARP packets on each untrusted port. To open
this screen, click
>
C o nfig ure
Fig ure 208
Configure > Port
The following table describes the labels in this screen.
Table 130 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure > Port
L ABEL
Port
*
Chapter 28 ARP Inspection
DESC RIPT IO N
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click this to reset the values in this screen to their last-saved values.
Adva nc e d Applic a tio n
.
Po rt
Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
DESC RIPT IO N
This field displays the port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make
them.
GS2220 Series User's Guide
> >
IP So urc e G ua rd IPv4 So urc e G ua rd Se tup
277
link on the top navigation panel to
Sa ve
>
ARP Inspe c tio n
>