Dhcp Snooping Port Configure - ZyXEL Communications GS1915 Series User Manual

Table 85 Advanced Application > DHCP Snooping > Configure (continued)
LABEL
Renew DHCP
Snooping URL
Apply
Cancel

23.3.1 DHCP Snooping Port Configure

Use this screen to specify whether ports are trusted or untrusted ports for DHCP snooping.
Note: If DHCP snooping is enabled but there are no trusted ports, DHCP requests cannot
reach the DHCP server.
You can also specify the maximum number for DHCP packets that each port (trusted or untrusted) can
receive each second.
To open this screen, click Advanced Application > DHCP Snooping > Configure > Port.
Figure 127 Advanced Application > DHCP Snooping > Configure > Port
Chapter 23 DHCP Snooping
DESCRIPTION
Enter the location of a DHCP snooping database, and click Renew if you want the
Switch to load it. You can use this to load dynamic bindings from a different DHCP
snooping database than the one specified in Agent URL.
When the Switch loads dynamic bindings from a DHCP snooping database, it does not
discard the current dynamic bindings first. If there is a conflict, the Switch keeps the
dynamic binding in volatile memory and updates the Binding collisions counter in the
DHCP Snooping screen (Section 23.2 on page
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click this to reset the values in this screen to their last-saved values.
GS1915 Series User's Guide
186
181).