Heartland VALUE Series Assembly Manual page 75

PARTS REQUIRED:
x2 WTC
2 x 6 x 49-3/4" (5,1 x 15,2 x 126,4 cm)
x2
VX
2 x 6 x 96" (5,1 x 15,2 x 243,8 cm)
BEGIN
Place VX eave trim flush along edge of roof panel (Fig. A).
1
Screw through roof panel into trim with 1-1/4" screws spaced evenly in a staggered pattern.
Install WTC flush to edge of roof panel and flush to installed eave trim VX.
2
Screw through roof panel into trim with 1-1/4" screws spaced evenly in a staggered pattern.
**Part WTC may need to be trimmed to fit**
Flush
Fig. A
3" (7,6 cm)
Screws
VX
Repeat installation on opposite side.
FINISH
Your eave trim is now installed.
12' x 12' EAVE TRIM
x8
1-1/4" (3,2 cm)
Screws
Evenly Spaced
3" (7,6 cm)
WTC
73
x58
1-1/4" (3,2 cm)
VX
WTC