Heartland VALUE Series Assembly Manual page 54

PARTS REQUIRED:
BEGIN
Align rafters over the wall studs.
1
Check that you have the measurements shown.
Secure rafters with (2) 3" screws angled at each end (Fig. A, Fig. B).
Secure rafters on opposite side.
Maintain the measurements between rafters.
12' x 12'
Rafter with
ONE GUSSET
facing inward.
Flush to
outside
of panel
Maintain the measurements between rafters.
12' x 16'
24-3/8"
(61,9 cm)
FINISH
Your rafters are now installed.
RAFTER INSTALLATION
12x12' 12x16'
x5 x7
Preassembled
x28 x36
DIMENSIONS ARE FROM OUTSIDE OF WALL PANELS.
DIMENSIONS TO CENTER OF RAFTERS.
24-3/8" 24"
(61,9 cm) (61 cm) (61 cm)
Fig. A
Screws angled
into top plate
DIMENSIONS ARE FROM OUTSIDE OF WALL PANELS.
DIMENSIONS TO CENTER OF RAFTERS.
24" 24"
(61 cm) (61 cm)
Fig. A
2-Gusset
3" (7,6 cm)
24" 24" 24"
(61 cm) (61 cm)
ALIGN OVER
STUDS
3" (7,6 cm)
Flush to inside
24" 24"
(61 cm) (61 cm) (61 cm)
ALIGN OVER
STUDS
3" (7,6 cm)
Flush to inside
Screws angled
into top plate
52
1-Gusset
x2
Preassembled
24-3/8"
(62 cm)
Rafter with
ONE GUSSET
facing inward.
Flush to
outside
of panel
of panel
Fig. B
24" 24" 24-3/8"
(61 cm) (62 cm)
of panel
Fig. B