Heartland VALUE Series Assembly Manual page 63

PARTS REQUIRED:
3
Install first 47-7/8" x 48" roof
panel flush to the installed panel
and flush at the peak.
Secure panel with (1) 2" nail
in each corner.
Move to the opposite end.
Using the unattached end of
the panel as a lever, move the panel
side-to-side until the top corner is
flush to the peak (Fig. B) and there is
a 3/4" measurement on the rafter
(Fig A).
Finish securing panel with (1) 2" nail
in each corner.
4
Install next 48" x 48" roof panel flush to
the installed panel and flush at the peak
(Fig. B).
Secure panel with (1) 2" nail in each
corner.
Move gable end rafter edge until it is
1/2" from the 2nd 48" x 48" roof panel
(Fig. C).
Finish securing panel with (1) 2" nail
in each corner.
5
Maintain spacing between the center of the rafters at the lower edge of the panels (Fig. D).
Secure panels with (1) 2" nail into each rafter, as shown.
Move to the top of the panel and keep spacing between the center of the rafters.
Secure panels with (1) 2" nail into each rafter.
24-3/8" 24"
(62,9 cm) (60,9 cm)
2" (5,1 cm) Nails
12' x 16' ROOF PANELS
47-7/8 x 48"
x2
(121,6 x 121,9 cm)
1/2"
(1,2 cm)
Fig. C
Gable
End Rafter
Gauge Block
Fig. A
3/4"
(1,9 cm)
NOTE: Measurements from inside of gable panels
24" 24"
(60,9 cm) (60,9 cm)
Flush
Flush
Fig. D
24"
(60,9 cm) (60,9 cm)
61
x18
2" (5,1 cm)
Fig. B
2" nail
in each
corner
24"
24"
(60,9 cm)
Flush at
peak
24-3/8"
(62,9 cm)