14.10 Automation Setup For Usl Dax Devices - GDC SX-3000 Installation Manual

Hide thumbs Also See for SX-3000:

Table of Contents

14.10 Automation setup for USL DAX devices

The SX-3000 server supports automation for USL DAX sound processor. Follow the steps below

to configure a USL DAX device in the server automation interface.

1. Click the [Add] button on the [Devices] tab and enter the name of the device. In this

case, it is "DAX". Set the device type to "USL-DAX" (see Figure 62).

2. Click [OK] and set up the device parameters for the USL DAX device.

3. Enter the IP address of the USL DAX device (see Figure 63).

4. Click the [Save] button to save configured settings.

SX-3000 Installation Manual

Figure 62 USL DAX automation device setup

Figure 63 Automation settings for USL DAX device

Page 39 of 43

Table of Contents