Remove Existing Interface Board/Placeholders From Projector - GDC SX-3000 Installation Manual

3.1 Remove existing interface board/placeholders
from projector.
Before installing the IMB, check the figures below to ensure proper placement.
3.1.2 Barco Projector Placement
Figure 3 shows an interface board (with SMPTE 292 inputs) connected to a Barco projector. This
board must be removed in order to install the IMB.
3.1.3 Christie Projector Placement
Figure 4 shows the location where the IMB should be installed on a Christie projector. Remove
any existing interface boards or placeholder faceplates from this position before installing the
IMB.
SX-3000 Installation Manual
Figure 3 IMB Placement on Barco projectors
Figure 4 IMB Placement on Christie projectors
Page 5 of 43
Remove for
IMB
installation
IMB
installed
here