Automation Setup For Server Gpio; Automation Setup For Projectors - GDC SX-3000 Installation Manual

14.4

Automation setup for server GPIO

The SX-3000 GPIO automation device settings can be configured from the [Devices] tab after
selecting the 'GPIO' device name.
If the output pulse width is left blank, the default value of 50ms will be used. If a different
output pulse width is required, the value can be entered in the 'Output Pulse Width' setting.
Click the [Save] button to save any changes made.
14.5

Automation setup for projectors

The SX-3000 server supports automation for Barco, Christie and NEC projectors. Follow the steps
below to configure a projector device in the server automation interface.
1. Click the [Add] button on the [Devices] tab and enter the name of the device. In this
case, it is "PROJECTOR". Set the device type to "PROJECTOR" (see Figure 42).
2. Click [OK] and set up the device parameters for the projector device.
3. Enter the IP address of the projector device (see Figure 43).
4. Set the correct model of the projector. The port number will automatically change to
the default automation port number for the model. If the projector is a Series 2
projector, check the 'Series 2' checkbox.
5. Enter the 'Login' and 'Password' for the projector if required.
6. Click the [Save] button to save configured settings.
SX-3000 Installation Manual
Figure 49 GPIO automation device settings
Page 33 of 43