Introduction; Equipment List - GDC SX-3000 Installation Manual

1

Introduction

This document is a guide through the process of setting up the SX-3000 with the projector,
storage bay, audio system, and automation devices used in cinema theatres.
Note: The currently supported software version for SX-3000 server is 9.0 or higher.
Note: In this manual there will be many instructions starting from the SMS screen. This is the
main page of the SX-3000 software that features the status of the show playing, the transport,
and the buttons to access certain menus of the software.
2

Equipment List

This section describes the equipment shipped with the GDC SX-3000.
The SX-3000 Packaging Includes:
1. SX-3000 Unit with proper projector face plate.
2. 2 x 10M RJ45 AES Audio Cable
3. 4 x 10M RJ45 GPIO Cables
4. 1 x Network Cable
PSD-3000P includes:
1. PSD-3000P Hard Drive Bay
2. 3x 2.5" Hard Drives
3. 3 x SATA Cables
4. Mounting kit for projector
SX-3000 Installation Manual
Figure 1 SMS Screen
Page 3 of 43
PSD-3000U includes:
1. PSD-3000U Hard Drive Bay
2. 3x 3.5" Hard Drives
3. 3 x SATA Cables
4. Hard drive door key