Connecting The Psd-3000P Drive Bay To The Sx-3000 - GDC SX-3000 Installation Manual

5.2

Connecting the PSD-3000P drive bay to the SX-3000

Note: On the bay PSD-3000P unit there are 4 hard drive bays and 4 SATA connectors. The unit
only utilizes 3 of the 4 bays. The 4
drive bay (Figure 6) corresponds with the SATA port (Figure 9) on the back of the unit.
To connect the PSD-3000P to the SX-3000, please use the following instructions.
1. Connect SATA ports 1, 2, and 3 on the back of the PSD-3000 to the eSATA ports
on the SX-3000. There is no particular order these connections.
Figure 9 SATA ports of the PSD-3000P
2. Plug in the 5V power supply and connect to the back of the PSD-3000P.
Figure 11 PSD–3000M Power Supply plug and Power Switch
3. Power on the unit with the switch next to the power plug. (Figure 11). Then
power on the projector with SX-3000 before moving on to the next steps.
Important Note: Always power on the PSD-3000P external hard drive bay before powering up
the projector.
SX-3000 Installation Manual
Figure 8 Hard Drive bays 1-3 of the PSD-3000P
th
bay and port is to be used as a back-up if needed. The Hard
Page 8 of 43
Figure 10 eSATA ports of the SX-3000