Automation Setup For Christie Act Devices - GDC SX-3000 Installation Manual

Hide thumbs Also See for SX-3000:

Table of Contents

14.8

Automation setup for Christie ACT devices

The SX-3000 server supports Christie ACT automation device. Follow the steps below to

configure a Christie ACT device in the server automation interface.

1. Click the [Add] button on the [Devices] tab and enter the name of the device. In this

case, it is "ChristieACT". Set the device type to "ChristieACT".

2. Click [OK] and set up the device parameters for the Christie ACT device.

3. Enter the IP address of the Christie ACT device.

4. The default setting for the 'Port' is displayed on the settings for the Christie ACT device.

Change this value if required.

5. Default control cues will be set up for a new Christie ACT automation device. Control

cues can be added or removed by clicking on the [+] and [-] buttons.

6. Click the [Save] button to save configured settings.

SX-3000 Installation Manual

Figure 58 Christie ACT automation device setup

Figure 59 Automation settings for Christie ACT device

Page 37 of 43

Table of Contents