Inserting The Imb Into The Projector; Projector Network - GDC SX-3000 Installation Manual

3.1.4 NEC Projector Placement
Figure 5 shows the location where the IMB should be installed on a NEC projector. Remove any
existing interface boards or placeholder faceplates from this position before installing the IMB.
Please refer to the projector manuals for more details on preparing the projector for IMB
installation.
3.2

Inserting the IMB into the projector

Please make sure the projector is powered off before installing the IMB on the projector.
Insert the IMB as shown in Figure6.
The IMB should slide into the projector on the rails provided by the IMB slot, and the IMB
faceplate should be flush with the other existing faceplates once properly inserted.
3.2

Projector Network

Connect the provided Cat 5e LAN cable form the SX-3000 Ethernet 2 port to the projector's
Ethernet port. Please see Section 8 for IP network instructions after the SX-3000 is installed.
SX-3000 Installation Manual
Figure 5 IMB Placement on NEC projectors
Figure 6 Inserting the IMB into the projector
Page 6 of 43
IMB
installed
here