14.11 Automation Setup For Usl Jsd Devices - GDC SX-3000 Installation Manual

14.11 Automation setup for USL JSD devices

The SX-3000 server supports automation for USL JSD-80 and JSD-100 sound processor. Follow
the steps below to configure a USL JSD device in the server automation interface.
1. Click the [Add] button on the [Devices] tab and enter the name of the device. In this
case, it is "JSD". Set the device type to "USL-JSD" (see Figure 64).
2. Click [OK] and set up the device parameters for the USL JSD device.
3. Enter the IP address of the USL JSD device (see Figure 65).
4. Select the correct model (JSD-80 or JSD-100) of the device the server is connected to.
5. Click the [Save] button to save configured settings.
SX-3000 Installation Manual
Figure 64 USL JSD automation device setup
Figure 65 Automation settings for USL JSD device
Page 40 of 43