Automation Setup For Ecna Devices - GDC SX-3000 Installation Manual

SX-3000 Installation Manual
Figure 50 Projector automation device setup
Figure 51 Automation settings for projector device
14.6

Automation setup for eCNA devices

The SX-3000 server supports the eCNA-10 automation system. Follow the steps below to
configure an eCNA device in the server automation interface.
7. Click the [Add] button on the [Devices] tab and enter the name of the device. In this
case, it is "eCNA". Set the device type to "eCNA_IO".
Page 34 of 43